WRD-XJ219×8.0mm Milling Saw
The working principle and characteristics of the equipment are as follows:
When the continuous rolling mill delivers the formed steel pipe to the flying saw, the saw is tracked to synchronize with the pipe speed, clamped with clamps, and the saw blades of the two sawing systems mounted on the rotating disc rotate, and feed radially under the drive of the AC servo motor.
At this time, the turntable is also rotating. The sawing system makes compound movement in the turntable and its own feed, and cuts the steel pipe along the section shape trajectory of the cut piece.
Then each system relaxes back to its original position and waits for the next working cycle.
Good cutting quality, no burr, high working efficiency and low noise. The operating system is equipped with touch screen, which is simple and convenient to operate. The shape and size of the product can be arbitrarily set, cutting parameters can be set, operation status and alarm status can be monitored.
|Steel pipe specifications:||Round pipe:Φ89～Φ219 mm|
|Square pipe:75×75～ 150x150mm|
|Rectangular pipe:100×50～ 200x100mm|
|Steel material：||Q235、Q345（σs≤ 600 MPa）|
|Feed direction：||Left feed|
|Forming method：||Constant rolling bottom line|